Rubber Molds for Concrete, 18x18x2 Wall Cap and Column Cap, Hearthstone, Paver

Description

Create your own custom concrete hearthstones, wall caps, column caps, and pavers
No release agent required, which saves money, time, and clean up, as well as easy, clean release of face color pigments, unlike plastic molds
Production quality molds can be used hundreds of times
Made in the USA from plastisol rubber, including recycled plastisol
Save tons of money and create your own custom colors
You can create your own hearthstones, wall caps, column caps, and pavers with Stone Master's rustic mold for concrete. The top is a stone, slate texture and the four sides are chiseled. The finished product that you pour will be 18" x 18" and 2" thick. You can also pour it thinner, if desired. No need to use release agent, so easy clean up. This professional quality mold will last you for hundreds of pours! The approximate size of the mold is 20.75" by 20.75" by 2.75" thick.
Manufactured Stone Basic Mixing Procedures Using A Pre-bagged Concrete Mix: This is one suggestion for mixing the concrete for manufactured stone. There are many other instructions available online, including videos. BE SURE TO USE A CONCRETE MIX THAT CONTAINS PORTLAND CEMENT. We recommend Sakrete Maximizer, as it has lightweight aggregate, is high strength, and yields more product, but there are many kinds you can use. Follow the manufacturer’s instructions for mixing. If using pigment, add desired iron oxide pigment to mixer (100% pure, no additives). These can easily be found on Amazon, etc. A plasticizer can be added to reduce the amount of water in the mix. Pour into the molds which may already have coloring additives… NO RELEASE AGENT NECESSARY. Vibrate molds to release air bubble. Cure in the molds for approximately 24 hours at the minimum of 70 degrees Fahrenheit before demolding. Higher humidity is desired. Molds can be covered with a tarp to retain more heat and humidity. Continue to cure demolded stones at 70 degrees or greater until ready.